G-Code in 3D Printing
Here are some common G-code commands that are used in 3D Printing
- Genera Movement:ex. G1 X10 Y20 Z30 E20 F1500 -- G1 - Move in a straight line to the specified coordinates. -- X10, Y20, Z30 - The target coordinates for the move. -- E20 - The amount of filament to extrude during the move. -- F1500 - The feed rate for the move, in mm/min.
; HEADER_BLOCK_START
; generated by OrcaSlicer 2.3.0 on 2025-05-20 at 13:12:43
; model printing time: 19m 14s; total estimated time: 25m 7s
; estimated first layer printing time (normal mode) = 5m 52s
; total layer number: 125
;_GP_TOTAL_LAYER_NUMBER_PLACEHOLDER
; model label id: 60
; filament_density: 1.26,1.26,1.26,1.26
; filament_diameter: 1.75,1.75,1.75,1.75
; max_z_height: 25.00